|

Many fungi are capable of rotting mature or
near-mature fruits of strawberry, grape, raspberry, blueberry and
blackberry. Serious losses can occur under favorable environmental
conditions for disease development. One of the most serious and
common fruit rot diseases is gray mold. The gray mold fungus can
affect petals, flower stalks (pedicels), fruit caps and fruit. In
wet, warm seasons, there is probably no other disease capable of
causing a greater loss of flowers and fruit. The disease is most
severe during years with prolonged rainy and cloudy periods during
bloom or during harvest. Although berries of all grape varieties are
susceptible to bunch rot, losses generally are greater on
tight-clustered varieties of Vitis vinifera and French
hybrids.
Young blossoms are usually very susceptible to
infection. One or several blossoms in a cluster may show blasting
(browning and drying) that may extend down the pedicel. Fruit
infections usually appear as soft, light brown areas on the fruit
which enlarge rapidly. Infected fruits remaining on the plant
usually dry up, "mummify," and become covered with gray, dusty
spores, which give the disease its name "gray mold." Fruit infection
is most severe in well-protected areas of the plant, where the
humidity is high and air movement is poor. On strawberry, berries
resting on soil or touching another decayed berry or a dead leaf in
dense foliage are most commonly affected. The disease may develop on
young green fruits, but fruits become more susceptible as they
mature. The disease is not usually detected until fruits are mature
at harvest time. After picking, mature fruits are extremely
susceptible to gray mold, especially if bruised. The handling of
infected fruit while picking will spread the fungus to healthy ones.
Under favorable conditions for disease development, healthy berries
may become a rotted mass within 48 hours of picking.
 |
 |
Early (left) and late (right)
stages of botrytis fruit rot on strawberry. Photos courtesy of
the Ohio State University
Extension. |
The gray mold fungus is capable of infecting a
great number of different plants. The disease cycle is very similar
for strawberries, grapes, blueberries and brambles. The fungus
overwinters as minute, black fungus bodies (sclerotia) or as
mycelium in plant debris, such as dead strawberry or raspberry
leaves. Recent research has shown that nearly all of the
overwintering inoculum in strawberry plantings comes from mycelium
in dead strawberry leaves within the row or planting. In early
spring, the mycelium becomes active and produces large numbers of
microscopic spores (conidia) on the surface of old plant (leaf)
debris in the row. Spores are spread by wind throughout the planting
where they are deposited on blossoms and fruits. They germinate when
a film of moisture is present and infection can occur within a few
hours.
Temperatures between 70 and 80 degrees F and free
moisture on the foliage from rain, dew, fog or irrigation water are
ideal conditions for disease development. The disease can develop at
lower temperatures if foliage remains wet for long periods. Grapes
and berries are susceptible to Botrytis during bloom and again as
fruits ripen. Recent research indicates that most fruit infection
actually occurs during bloom; however, symptoms usually do not
develop until close to harvest. During bloom, the fungus colonizes
healthy or senescing flower parts, often turning the blossoms brown.
These blossom infections establish the fungus within the receptacle
of the young fruit as a "latent" or "quiescent" infection. The
fungus generally remains latent in developing (green) fruit until
the fruit starts to mature (the fruit sugar content increases and
the acid content decreases to a level that supports fungus growth),
at which time the fungus becomes active and symptoms (rot) appear.
Thus, the most critical period for applying fungicides to control
gray mold is during bloom. This is an important point to remember
when considering fungicide applications for controlling this
disease.
• Select a planting site with good soil drainage
and air circulation. Plants should be exposed to direct sunlight.
Plant rows with the direction of the prevailing wind to promote
faster drying of foliage and fruit.
• A good layer of straw mulch (or other material)
between the rows or around the plants aids greatly in controlling
fruit rots. The mulch acts as a barrier that reduces fruit contact
with the soil.
• Proper spacing of plants and timing of fertilizer
applications are also important. Excessive applications of nitrogen
fertilizer, especially in the spring before harvest, can produce
excessive amounts of dense foliage. Shading of fruit by thick
foliage prevents rapid drying of the fruit during wet periods and
creates ideal conditions for disease development.
• Good weed control is very important. Weeds
prevent air movement in the plant canopy. This slows drying time of
flowers and fruits and increases the chances for infection. Pick
fruit frequently and early in the day as soon as plants are dry.
Cull out all diseased fruit but do not leave them in the field.
Handle fruit with care to avoid bruising. Refrigerate promptly at 32
to 50 degrees F to inhibit the gray mold fungus.
• Fungicides are an important disease management
tool in commercial plantings, but are generally not effective unless
they are timed properly and used in conjunction with the above
cultural practices. Homeowners are encouraged to emphasize the use
of cultural practices in order to avoid the use of fungicides.
Adapted from Michael A.
Ellis, Ohio State University Extension, 1999

|